Power UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE one
Common Description
This power unit is created exclusively to the little lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit has been extensively used during the marketplace of logistic units which include minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed by the solenoid valve with all the velocity controlled by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This electrical power unit is developed solely for your medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve along with the velocity managed by the adjustable needle valve. Once the lift rises to a high positoin, but the power supply is lower, the decreasing movement is controlled from the guide override perform.
Power UNITS FOR LIFT TABLE 3
Basic Description
This power unit is created exclusively for the substantial lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve plus the pace managed by a stress compensated movement handle valve.
Electrical power UNITS FOR LIFT TABLE four
General Description
This electrical power unit is developed solely for your big lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as speed controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the energy supply is reduce, the reducing motion is managed through the guide override perform.
Unique Notes
one. This electrical power unit is of S3 duty cycle, which could only function intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean all the hydraulic elements concerned prior to installation of the energy unit.
three. Viscosity of the oil shoud be 15~46 cst,which need to also be clean and totally free of impurities.N46 hydraulic oil is advised.
four. Oil transforming is required right after the initial one hundred operation hrs,afterwards after each and every 3000 hours.
5. The power unit shown is made to be mounted vertically.